Joined Nov 2002
Help w/ 4mm bullet connectors
My new Turnigy Nanotechs 6s & 5s-5000s have been coming with 4mm bullets c/w polarized plastic sleeves. I've been cutting these stock connectors off & replacing them, standardizing on 6mm bullets for 100 to 120amp apps. I did have a stash of these 4mm bullets unused, so have been taking these said polarized sleeves from my new stash & plugging them into the 6mm terminals on my packs as protection against accidental unintended contact during storage. They fit nicely. But now my stash of 4mm is running out & I have all these cut off ones still but finding it impossible to remove the wire/connectors still captured inside their polarized sleeve protectors.
Can anyone share with me their method of removing these captured connectors so I can recycle these sleeves? I know, these sleeves slip on newly soldered 4mm bullet pairs so easily; but I just have not been able to get the bullets off the groove inside the sleeves w/out destroying the sleeves. Your input will be much appreciated. TIA.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||5x 2822 Emaxx Motors w/ Prop Savers & Bullet Connectors||bob4432||Aircraft - Electric - Multirotor (FS/W)||4||Aug 05, 2011 10:24 PM|
|Wanted||4mm Male Bullet connectors||sodbuster 1||Aircraft - Electric - Batteries & Chargers (FS/W)||1||Aug 03, 2011 04:38 PM|
|Wanted||4mm bullet connectors||localbuyer||Aircraft - General - Miscellaneous (FS/W)||1||Mar 12, 2011 11:59 AM|
|Sold||4mm Bullet Connectors w/Heat Shrink||BD Flyer||Aircraft - Electric - Power Systems (FS/W)||1||Aug 07, 2009 08:42 PM|
|Found||WTB: (2) 4mm gold bullet connectors||akcarl||Aircraft - Electric - Power Systems (FS/W)||2||Nov 07, 2005 08:19 PM|