Joined Jan 2012
My custom HexaCopter Arm/Motor Mount
Attached are two pictures of my homemade hexacopter arm/motor mount.
Carbon fiber tube is from HobbyKing, here
I designed the tube collar in AutoCad and had it fabricated at Shapeways. The collar design can be seen here. I designed the collar diameter to be ~0.2mm smaller than the tube, and as you can see it comes it two halves, which are fastened together using 3mm bolts.
The material for the collar is the 'strong, black and flexible' material - from my testing @ ~16000 rpm, it seems stable and doesn't crack/warp. I ran the motor at a variety of speeds, everything seems solid.
Comments? (And, before you ask, yes - I was very careful cutting the carbon - I used a sealed full head hood, and used my scuba tank/regulator as an air source - I'm paranoid after reading some of the things on this forum
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||6 Custom Aluminum HET Motor Mounting Setup - $12.00 ea Shipped||gabrielisrael||Aircraft - Electric - Power Systems (FS/W)||3||Sep 01, 2012 11:16 PM|
|For Sale||4 - Custom Aluminum HET Motor Mounting Setup - $12.00 ea Shipped||gabrielisrael||Aircraft - Electric - Airplanes (FS/W)||0||Mar 18, 2012 05:44 PM|
|For Sale||4 - Custom Aluminum HET Motor Mounting Setup - $12.00 ea Shipped||gabrielisrael||Aircraft - Electric - Airplanes (FS/W)||2||Mar 14, 2012 12:40 PM|
|Discussion||Mount props/motor on top or under arms?||henkster||Multirotor Talk||5||Mar 08, 2012 03:46 AM|
|Question||Motor mounts that will fit on 12mm arms?||malcr001||Multirotor Talk||18||Jan 13, 2012 05:07 PM|