|Feb 18, 2002, 11:58 AM|
Best adhesive for sheeting foam wings?
Iím almost ready to do my first balsa sheeting job and was wondering what my options were for gluing down the balsa. Itís a gray foam (insulation board) wing with a 50Ē span, 9Ē cord, NACA 2412 profile, balsa leading and sub trailing edges (full span ailerons), and overlapping carbon tube spars, Iím going to sheet it with 1/16 balsa. 3M spray glue would be easy as it eliminates the need for clamping, but I donít know if it will bond as well as Probond or epoxy, especially where the skin meets the leading and trailing balsa edges. Whatís the best glue for the job?
All advice greatly appreciated
|Feb 18, 2002, 06:01 PM|
Joined Jul 2000
If I were doing a wing w/balsa leading and trailing edges, I'd go for either 77, or probond on the skin-to-foam contact areas, and shoot a little CA on the skin to balsa L/T edge contacts.
|Feb 18, 2002, 06:30 PM|
Just an alternative....
I used the ole white glue, aka Elmers, I used a brush, poked a few reservoir holes in the foam, and thinly spread the glue over the foam wings, then sandwiched both wings, back into their respective counterparts, stacked the ole phone books on top for 24 hours, and walla! Of course my wings were 1/32 sheet, 1/16 gets abit hard to fold
I have used 3M 77 and other spray adhesives, but against foam, in heat and cold, its not worth the risk to me, I have seen the spray glue give at times, foam is not very forgiving, however I am not saying my way is best.
After the initial sheeting, I would use epoxy for the LE and TE.....
|Feb 19, 2002, 12:24 AM|
Joined Apr 2001
On my one and only foam wing, I used water based contact cement on the advice of the kit builder ( Jet Hanger Hobbies F 86 )
Very easy and LIGHT. Also very unforgiving as it really is "contact" cement. Any contact is final.
No separation problems. Second owner had engine out and crashed it. Bad damage, but sheeting did not separate at all from foam in the wing.
I have tried epoxy, but was amazed at how much weight it added! So much I scrapped it and built a balsa wing.
|Feb 19, 2002, 05:16 PM|
Joined Aug 2000
the very best....transfer tape...it is the easiest,lightest and most foolproof. Dodson Designs originated this. i used this method on many sailplane wings without a problem.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion Best adhesive for sheeting a foam wing?||Valid8r||The Builders Workshop||4||Sep 12, 2006 06:48 AM|
|Best adhesive for balsa over foam ?||dvint||The Builders Workshop||9||Dec 29, 2004 04:02 PM|
|Question what is the best airfoil for undercambered foam wings?||duaner||Foamies (Kits)||13||Aug 06, 2004 11:23 AM|
|Best adhesive for Blue Foam||Hawker||Foamies (Kits)||14||Oct 09, 2002 09:57 PM|
|Best filler for white foam (uk) ?||BioHazard||Beginner Training Area (Aircraft-Electric)||2||Oct 01, 2001 11:45 AM|