|
||
|
Quote:
|
|
|
||
|
|
||
|
Quote:
|
|
|
||
|
|
|
Here are 2 pics of what I recieved, doesn't look right! correct me if I am wrong. where there supposed to be shorter standoffs with this?
|
|
|
|
||
|
Quote:
The long arms are for the battery support/roll cage/FC protector |
|
|
||
|
|
|
|
|
|
|
|
|
can't decide to use a power distribution board or not. I have it suspended in between the decks with tiny standoffs so I can access both the top and bottom terminals.I also have the Photoship One dist. board which is green but smaller. only 2g difference between aluminum hardware and nylon so I think I'm going to jewel it up a bit since its so pretty as is. I will be lighting it with clusters of SMD LEDs, either 2 rows of 3 for 6 total, 1 watt. or strips. Whichever gives off the best edge lighting I guess.
Going to be using Coptercontrol, Plush 10a's and GWS 5x3x3 and 3s 1000mah for power. May put some fpv on this little guy if he flies well! I'm excited about this mini! |
|
|
|
|
|
I did find a link last night for the m3 standoffs....
http://uk.digikey.com/1/3/hex-screwdriver loads on there , ill have a look through my heli spares later to see if anything is suitable , as for the plates needing to be 50mm , ill try and find some 2mm perspex/poly later , its not worth ordering anything at the minute as UK post might as well just shut down , its just taken 7 days to get a letter that was posted first class 70 miles away lol.. |
|
|
|
|
|
I had to make a power spider, a small one. Today I learned that it's a massive pain to prepare everything for the small frame. You have to cut the wires very close to the ESCs, motors etc and the power spider is very very small with roughly a centimeter of wire between the 4 plugs. There is little room for error here, which is why I ordered 5 motors and 5 ESCs. Just in case anything goes wrong.
I also ran out of spacers and screws, so I may have to use regular washers and nuts to hold the FC and battery plate in place. |
|
|
|
|
|
|
|
|
|
||
Thread OP
|
Quote:
so sorry , I think 15mm m3 female to female hex standoff missing. I will send to you missing parts with new 45mm hole upper and lower parts. |
|
|
Last edited by Widelec; Dec 16, 2011 at 05:20 AM.
|
|
Thread Tools | |
Similar Threads | |||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
Discussion | BambuCopter *BlueBird QuadCopter, BlueBird TriCopter* SmallQuad 450 AirFrames | Widelec | Multirotor Drone Talk | 343 | May 25, 2013 03:00 PM |
Discussion | HK has a new mini quad frame | Pintac | Multirotor Drone Talk | 20 | Sep 28, 2011 10:04 AM |
Sold | Quad frame for sale!!! previously listed. as full quad. | tc3wins | Aircraft - Electric - Multirotor (FS/W) | 3 | Aug 25, 2011 08:56 AM |
Sold | Mini Quad with G10 frame RXR | tc3wins | Aircraft - Electric - Multirotor (FS/W) | 4 | Jul 21, 2011 11:05 PM |