|May 12, 2013, 05:33 AM|
New Zealand, Northland, Totara North
Joined Feb 2012
Need help chosing motor
I am designing a 700mm long powerboat for rescuing sailboats and for photography. Its single chined and is 200 mm wide. I have no need to go more than 10 knots. I need more tourque than speed. What kv rating brushless motor do you recomend. Thanks vey much
|May 12, 2013, 06:01 AM|
Its realy going to depend on the prop, battery voltage and 10 knots is fairly fast. So its a planing hull. I reckon something around a 36-series motor 800-1000 kv on 12 volts and a 40-45 mm prop would be a resonable educated guess going on the basic info of your boat
|May 12, 2013, 09:33 AM|
Hmmm. Do you want to go brushless or brushed.
I would recommend something along the lines of a Graupner 700BB motor for towing. You would need a small 12volt volt sealed lead acid battery like the one used to backup a home alarm system. I would try a 40-45mm prop. You will have to do a few test runs with different pitch sizes to see what works for you. You will need a ESC for brushed motors as well. I have looked into the same setup for a 700mm boat of mine years ago. I was sad to find brushed motor setups are outdated and anybody who still sells this stuff is way overpriced.
At least this guys prices are reasonable, sadly there is no water cooling.
If you want to go brushless with lipo batteries, your world has opened up to a fiesta of options and fun. (for the same money or less)
You can start by paying around a hundred dollars for a good lipo charger that will give you years of good service and meet all your battery needs.
You can research plenty of motors, but this is what I've been using as a 550-700 motor replacement. Kinda big, but short enough to fit in the same areas as a 550-700 brushed motor.
Speed Control with reverse
Lipo 2s 7.4volt You got room for two!!
|May 12, 2013, 09:55 AM|
55 turn integy lathe motor. $27 ebay and very low amp draw. Brushed Mtroniks speed control. It wont do 10 knots but will swing a 2 inch prop quite well with no water cooling. Pulls this 55# tug around. I have also used a $70 Pittman in this model and the results were the same.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Help Needed on chosing a glider with motor in the fuselage||woreoutpilot||Sailplane Talk||3||Jul 21, 2011 07:28 PM|
|Discussion||Help Needed on chosing a glider with motor in the fuselage||woreoutpilot||Electric Sailplanes||2||Jul 16, 2011 03:16 PM|
|Discussion||Help Needed on chosing a glider with motor in the fuselage||woreoutpilot||Scale Sailplanes||2||Jul 15, 2011 10:13 PM|
|Need help chosing a new S400 plane||96S14||Parkflyers||3||Nov 04, 2002 06:13 PM|
|Need help chosing trainer, 35" or 48" Herr Eng. piper cub!||rvillegachapa||Beginner Training Area (Aircraft-Electric)||26||Apr 21, 2002 12:00 PM|