|Dec 27, 2003, 11:29 PM|
Joined Dec 2003
Ni-cad 1400 ae Charging help
I have a super brain 959 Charger and i am going to charge my 8kr 1400 ae batteries for the first time Could someone give a newbie a few tips on how to charge. I have had 3 gas planes for a while now and wanted to try electric, so i got a wing warrior.
Any help would be great
|Dec 28, 2003, 08:13 AM|
Joined Aug 2000
Welcome to the forums Todd.
The best thing for your pack is a slow charge at 140ma for 12-16 hours. This equalizes the voltage of the individual cells within the pack. Then you can fast-charge at up to 3 amps and discharge at up to 20 amps. Any higher discharge and the pack voltage drops alot.
If your charger will not go that low, perhaps you have a Tx charger that you could make an adaptor to fit your pack (observe proper polarity) and charge for 24-30 hours instead. They should be warm when you finish.
I think you'll like flying electric.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Charging Ni-Cad/Nickel Metal||billrcpilot||Batteries and Chargers||2||Oct 19, 2006 09:03 PM|
|Discussion||Charging Ni-Cad||Emceeme2000||Batteries and Chargers||5||Jun 08, 2006 10:53 AM|
|FS.....7 Cell Ni-Cad 600Mah AE||kindjordan||Aircraft - Electric - Airplanes (FS/W)||1||Oct 20, 2003 07:19 PM|
|Ni-MH Charging Help||Trash Master||Batteries and Chargers||2||Jan 06, 2003 07:45 AM|
|Charging 150 MaH Ni-cad with Apex charger||YEAP CHIN POH||Batteries and Chargers||0||Dec 19, 2002 09:18 PM|