Hi,

This is our new IMU 9DOF breakout board. The L3GD20 gyro is the replacement of the L3G4200D. The footprint, the code and the I2C address is the same.
The LSM303DLM is an 3-axis acceleration and magnetic sensor.

The board can be use with 5V and 3.3V microcontroller.
It's here http://www.drotek.fr/shop/en/60-imu-...netometer.html

See you soon.

JP

Just pumpin' them out eh?
Looks like you're running a successful business, time to get a site sponsor badge?

Using L3G4200D gyros now and was going to give the L3GD20 a try since it has a higher resonant frequency. When looking see you make a module but was curious about your addressing statement.

The Slave ADdress (SAD) associated with the L3GD20 is 110101xb. The SDO pin can be used to modify the less significant bit of the device address. As the SDO pin is connected to voltage supply, LSb is ‘1’ (address 1101011b).

So with your module i2c read/write are D6h and D7h correct?

Originally Posted by drotek

The Slave ADdress (SAD) associated with the L3GD20 is 110101xb. The SDO pin can be used to modify the less significant bit of the device address. As the SDO pin is connected to voltage supply, LSb is ‘1’ (address 1101011b).

Originally Posted by pug398

So with your module i2c read/write are D6h and D7h correct?

Yes for sure.