United Kingdom, England, Sheffield
Joined Dec 2014
Hubsan q4 error codes
Just found this forum after searching for a resolution to my problem.
I have a Hubsan q4 nano copter.
Been flying great, but after it's last flight it now refuses to power the motors.
I power on and sync up, all fine, but then the forward left leds (blue and viewed from behind) blink 3 times then pause and repeat and none of the motors will power up.
It is obviously an error code, but I cannot find anything anywhere, does anyone know what could be the issue.
I have tried the following:
disconnected the battery
tried to recalibrate the controller (cannot do this as even though both tx and rx sync that is it)
fully charged the copter and tried to recalibrate.
Any advice is appreciated.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|New Product||Estes Proto X Nano RTF/Hubsan Q4 Nano/Estes Syncro Nano||FieldofDreamsFlyer||Mini Multirotors||5464||Today 01:56 AM|
|Help!||Hubsan Q4 will NOT bind to own radio!||vze33jng||Mini Multirotors||2||Yesterday 05:22 PM|
|Discussion||Hubsan Q4 (H-111)||mikefromgermany||Mini Multirotors||60||Apr 12, 2015 07:54 PM|
|Discussion||binding a hubsan Q4 to a new controller?||animaniac||Mini Multirotors||1||Nov 30, 2014 11:01 AM|
|Help!||350 qx error.one beep no LED error code||pixelmills||Multirotor Talk||1||Sep 09, 2014 06:48 PM|