Selling my MikroKopter Hexa:
Video of the hexa flying can be seen here: Watch Video even though it looked calm the wind was swirling around at low level. It was smoother higher up. As can be seen it flies well and is quiet and has plenty of power even on 3s lipos... if you use 4s lipos on it it would climb like a rocket!
Flight Controller: Genuine Mikrokopter 1.3 with 0.86d firmware loaded. Has the Recom 5v regulator and pressure sensor fitted.
Esc: 6 x Turnigy Plush 30a with a precision I2c to PWM convertor
Power distribution: AfroCtrl power distribution card
Motors: 6x Turnigy 2213 840Kv
Propellors: 6x 10x6 (4 spare propellers provided)
Lipo: 2x Flightmax 2200 3s (25c) each will give 5 -7 minutes of flight time.
Frame: Homemade Aluminium and Glass Fibre hexa frame with nylon landing gear looks like the
original MK hexa frame.
This is a neat and well put together hexacopta with a genuine MikroKopter FC it flies nice and just requires you to add your own RX The motors and flight controller are mounted on Alphagel washers to reduce vibration and all the props including the spares have been balanced. It has enough power on the 3s lipos to carry my sony webbie and I have tried it on 4s and it has plenty of power to spare without the motors getting too hot even after 12 mins of flying.
£275 plus shipping.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Geotagging in Mikrokopter Hexa||Lars N||Multirotor Talk||3||Jan 06, 2011 01:20 AM|
|Discussion||Questions about buying Mikrokopter Hexa XL for aerial videography/photography||tupelo||Multirotor Talk||3||Jan 04, 2011 05:05 PM|
|Discussion||The buzzer is not working on the hexa Mikrokopter||Itzik Ronen||Multirotor Talk||0||Sep 18, 2010 06:29 PM|
|Discussion||Questions about hexa Mikrokopter||wac||Multirotor Talk||1||Aug 24, 2010 09:02 PM|