Joined Aug 2012
recently i bought new airplane: 3DHS Slick 89"
the setup is:
5x Hitech 7955 servos.
HS-430BH throttle servo.
R6208SB 2.4GHz Receiver (Futaba)
Thunder Power G6 Pro Lite RX 2700mAh 2S
I have no smoke system installed.
what is the maximum amperes my receiver will need to get in hard 3d flying.
I think it's around 12amp with 15amp peak. correct me if I'm wrong..
and the main question is which switch i need to combine? HD is for sure . but HD can pass 12amp continuous? what about SuperRocker switch? which AWG should be in the switch?
and yes, i want only 1 battery for the receiver
It's not a Slick, I have an SBach 50cc with all 7955 servos and a Red Aero MXS-R with all 7955's.
I dunno what you consider "hard 3D" but this is my plane putting around....
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||Jr HD deluxe Gold switch and Futaba HD Switch.New$15 for both.||epc2||Aircraft - General - Radio Equipment (FS/W)||0||Jan 23, 2011 08:20 AM|
|Sold||JR HD Switch and Futaba HD switch NIB $14 shipped.||epc2||Aircraft - General - Radio Equipment (FS/W)||0||May 14, 2010 10:49 PM|
|For Sale||APC props/JR HD switch/Spinner/LMA/Xtals/GWS stuff||RCFEVER||Aircraft - General - Miscellaneous (FS/W)||7||May 10, 2007 08:15 AM|
|Sold||HITEC HD SWITCHES & ACCYs||RCPIG||Aircraft - General - Radio Equipment (FS/W)||2||Apr 21, 2007 01:13 PM|
|Sold||Duralite 4000 Lion RX package w/6v reg w/HD switch and more||AMainMaker||Aircraft - General - Radio Equipment (FS/W)||1||Mar 30, 2007 10:45 AM|