|Jan 26, 2014, 02:00 PM|
Outboard Pass Transistor
I need to increase the current output of an LM338T Voltage regulator. I've found some circuits that suggest an "outboard pass transistor", and they look like they will do the job, but they don't list an actual part number for the transistor, just the schematic symbol that shows a PNP transistor.
My question is this, I have some NPD6020P transistors availible, would they work OK in this application? They are logic-level MOSFETs, here's the data sheet , but I don't know enough theory to know if they would be suitable. Or would I be better off with something else?
Thanks for any help, guys!
|Jan 29, 2014, 08:24 AM|
try a MJ 4502 ... or TIP 36 or BD 250
that should do it ...
or also use 2 or 3 338 in // ( see 338 or 350 datasheet for the balancing circuit )
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Hitec Flash 5 transistor identification||scarabrae||Radios||0||Jan 07, 2014 01:39 AM|
|Discussion||Problem Lawmate 1.2 Ghz what kind of chip (output transistor)||Sagitarrius||FPV Equipment||0||Jan 04, 2014 12:27 PM|
|Question||LED driver transistor circuit for Arduino||bdelapen||DIY Electronics||24||Dec 04, 2013 01:15 AM|
|Sold||Vintage Outboard Cabin Cruiser Fiberglass Hull and Deck for K&B Outboard?||Tollytime||Boats (FS/W)||2||Jul 25, 2012 03:58 PM|
|Wanted||looking K&B 7,5 outboard engines.....or OS 3,5cc outboard engines.||fekete csaba||Boats (FS/W)||4||Mar 10, 2010 01:39 PM|