Joined Feb 2016
Wooblering/Jittering problems with zmr250
Hi to everyone,
I've been building a zmr250 lately and I have a huge stability problem with it
-Taranis x9d plus
-FrSky X4RSB (over sbus)
-Naze32 acro rev6b original (betaflight 2.2.0 and 2.3.2)
-Littlebee 20A (calibrated)
-Dys be1806 (new and tested props)
-Pdb Quadrevo powerosd pro
Everything boots up fine.
I have a major problem with jittering no matter what pid calculator I use.
Managed to fly it touching heavily the pids, when a lot of people is flying arround me without even touching them, so I guess something is not as it should.
Where should I begin? I've spend most of my savings on it... so I'm feeling really down now...
Any help/advice/ideas will be much appreciated...
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Jitter problems with gyro / elevon mixer combination||Moelich73||Aerial Photography||24||Dec 22, 2011 03:43 PM|
|Discussion||Jitter problems with gyro / elevon mixer combination||Moelich73||FPV Talk||3||Dec 04, 2008 10:21 AM|
|Problem with piccoboard plus! Jitters||ZiariM||Micro Helis||17||Aug 10, 2005 05:30 AM|
|Electron 6 Servo Jitter Problem with Tx Off and 5 Cell||Z06kal||Hitec/Multiplex USA||1||Jul 08, 2004 05:29 PM|
|Electron 6 Servo Jitter Problem with Tx off and 5 Cell Battery||Z06kal||Radios||1||Jul 08, 2004 04:24 PM|