ZMR250 Indoor hull project, problem
I'm building an indoor hull for my ZMR250.
It's 2 pieces, bottom with the prop openings, and top to attach to the quad, and stiffen it.
I flew without the top piece, bottom piece just pressure fit on with no problems.
When I finished the top, and glued them together I thought I was good to go. The problem now is that it spins counter clockwise, starting before it's even off the ground. I popped it up, and even with full right rudder it spins.
I checked the hull for prop damage, and there isn't any. So I know none of them were rubbing.
The gaps between the props and hull are about 3-6mm. I'm sure equal gaps would be ideal, but could this make it spin? The gaps should be the same as they were without the top.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||Joysway UH-1 (Project hull)||Fidelity101||Boats (FS/W)||46||Oct 25, 2014 06:48 PM|
|Discussion||Problem with turns and hull roll||BenVK||Scale Boats||44||Aug 02, 2014 12:44 PM|
|Discussion||Boat hull frame projections||redcraftmodels||Dock Talk||1||Jan 12, 2014 01:59 PM|
|Looking For a Hull (Project boat||helifan||Boats (FS/W)||0||Jan 06, 2005 09:22 PM|