|Yesterday, 11:59 AM|
Joined Jun 2005
Brushless Retractable landing gear setup
SO I purhased this kit from aliexpress....
I have it all setup but cant get it to work. I have the UBEC connected to a 3s battery while the to motor wires enter a y-harness then connect to the UBEC. The signal wire from the y-harness is then connected to my receiver. I can get the gear to make any noises or do anything but my receiver is powered and connected and the UBEC is supplying power. Any suggestions on how to troubleshoot?
|Today, 08:04 AM|
United States, CA, Huntington Beach
Joined Jan 2013
Try plugging just one retract in at the time without the legs to see if that helps. It may be that your BEC does not provide enough current. I looked at the ad for the retracts and there was no voltage specified so it's only a guess that it's 3.3 V.
You said you had a 3S battery connected to your you BEC but didn't mention what the output voltage was of the BEC. If it's a variable allowing 3.3 and 5 V I would try this report three first and then the five.
Short of that it may be you got defective units.
Hope that's of some help.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|For Sale||DJI F550 Zenmuse H3-3D Retractable landing Gear **FULLY LOADED**FPV SETUP**||Lroc130||Aircraft - Electric - Multirotor (FS/W)||2||Jul 05, 2014 12:28 PM|
|Discussion||retractable landing gear setups for a cinestar 8||antihero138||Multirotor Talk||0||Apr 10, 2014 03:18 PM|
|Sold||NEW PRICE RC Lander Large Metal Electric Retract Landing Gear||bwoollia||Aircraft - General - Miscellaneous (FS/W)||8||Oct 29, 2013 03:34 PM|
|Question||Is there cheap retractable landing gear?||flohio117||Multirotor Electronics||4||Oct 24, 2013 12:40 PM|
|For Sale||DJI Flamewheel 550 Retractable landing gear||cfrea||Aircraft - Electric - Multirotor (FS/W)||0||Sep 27, 2013 02:38 PM|