|Mar 06, 2014, 10:38 PM|
Joined Mar 2014
hi. im new here. and need help to reverse GWS s36/std servo
does anyone know how to reverse the GWS s35/std motor using pic16f877a??
here's my code
device = 16f877a
trisb = 0
pulsout portb.0,300 ----> seem's working in this code for forward
pulsout portb.1,100---> this one is not working for the reverse..
kindly help me..
this is for our project study..
thank you somuch.
and more power.
|Mar 09, 2014, 09:45 PM|
Joined Oct 2005
Normally we refer to PWM for controlling GWS servos including this mentioned S35/STD. That is 1.5 ms or 1500 μs meant for its neutral position, while PWM signles less than 1.5 ms make it turn left continuously, while more than 1.5 ms turn right continuously.
There are two ways for changing its rotating directions:
1. Switch the leads on the motor at the inside of this servo, but this way is NOT recommended by GWS. YOu have to take your own risks if you'd like to do so.
2. Switch the direction that you fix the servo on your device. ie, if the servo arm was at the right end, pull the entire servo off your device, turn it around, make the servo arm at the left end, then fix the servo on your device. Putting the servo upside down is another way to go if you do not mind it.
Hope this could be helpful.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||i am new and i need help for programming of GWS servo motor S35/STD. need to reverse||picbot||Robotics||0||Mar 06, 2014 10:05 PM|
|Help!||im new with driving so i need help? nitro.||user101||Nitro and Glow Power Cars||13||Dec 02, 2013 05:06 PM|
|Discussion||Help needed with GWS MINI STD servo||dvsvkimo||GWS (Grand Wing Servo)||1||Mar 27, 2009 10:05 PM|
|Rave||Hi Im new here and need help Please||roundthebend||Micro Helis||11||Aug 01, 2005 02:20 PM|