|May 05, 2013, 01:54 PM|
Xflr and gap TE
I've bugged Tom enough.... Now, it's time to bug you guys!
So, I want to gap the training edge of my airfoil .02"
I see the gap function, but I don't understand what % cord to use.
Also, when I export the dat files and change the cord how is that going to scale correctly?
|May 05, 2013, 07:58 PM|
I've just been out of pocket Will. I replaced the heat pump / AC in my house and shop this weekend.
I always set the TE thickness in XFLR to be 1 / chord*.3mm (.011") for DLGs. It could probably be a bit thicker for TD stuff.
The thought is that you want all of your stations to scale up to a .3mm TE thickness. If you have a 200mm chord for example, you would have a TE thickness of 1/200*.3 in XFLR. When you import it to Rhino it will be dimensionless as a point cloud and the airfoil will be 1mm long. Scaling it times 200 to make the chord correct will scale the TE to exactly .3mm.
Clear enough? I know I shared the equation before but I didn't explain it fully.
|May 06, 2013, 01:44 PM|
Ok, for the follow up on XFLR and TE Gap.
The math needs to be as follows.
Desired T.E. Gap/ Wing Cord * 100
I used the default blending distance
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion Wing Ribs with only sheeting for TE???||Atomikbohm||The Builders Workshop||7||Mar 29, 2013 11:23 PM|
|Discussion How to fill in gaps when strength is needed?||rwpeek||The Builders Workshop||9||Mar 21, 2013 09:52 PM|
|Question Should you seal your hinge gap?||3Daddict||3D Flying||26||Feb 22, 2013 11:50 PM|
|Discussion Gap seal and hinge tape||Flying-Addict||Slope||1||Feb 18, 2013 09:41 PM|
|Discussion Te'o Story||Indiana_Geoff||Life, The Universe, and Politics||2||Jan 20, 2013 08:39 AM|