|Feb 25, 2013, 07:04 PM|
Fixed Trike Landing Gear Location
Best location or rule of thumb for trike gear?
I have never done (successful) landing gear on a scratch build, trike or otherwise. I was wondering where is the best location, fore & aft. Perhaps nose gear far forward out to where I think the nose/fuse could handle the shock of a bad landing? The mains perhaps 1/2 the distance behind the CG that the nose gear is in front of the CG?
0. Delta wing with fuse, pusher prop.
1. I will not have steerable nose gear. Too complex this go 'round.
2. Delta wing, flat bottom config, so lots of room on bottom to play with.
|Feb 25, 2013, 09:24 PM|
Main gear on a delta should have the main gear just behind the CG. Just enough to tilt the nose down if you were to push the tail to the ground. Should sit on the ground with the nose slightly high in order to rotate at takeoff. Built a few of them.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Sold NIB Airfield (FMS) 1400mm Spitfire Kit, Fixed Landing Gear, $90 or BO, LPU Irvine CA||ek123||Aircraft - Electric - Airplanes (FS/W)||2||Jan 21, 2013 11:19 AM|
|Question Any "lawful" location for a rare fixed landing gear?||blacksmith2||Pusher Prop Jet Models||5||Aug 01, 2010 11:23 PM|
|Sold T-28 Landing Gear with Robart Trike Gear Strut Covers & Dubro Super Lite Wheels||Sammy70||Aircraft - Electric - Miscellaneous (FS/W)||3||Jul 11, 2010 08:55 PM|
|Best landing gear type for Easy Star -- trike or tail dragger?||JohnSoPA||Foamies (Kits)||11||Aug 07, 2008 11:15 PM|
|Help turning E-starter to trike landing gear||sokmeister||Parkflyers||2||Dec 19, 2003 05:23 PM|