|Oct 08, 2012, 04:27 PM|
Joined Oct 2012
Engine frozen up
Greetings, I have an old Enya fuel engine that I bought in the 80's but never used. I want to revive it. I soaked it in kerosene for 2 weeks but it's still frozen. I'm hesitant to take it apart. Worried that I might damage some seals or not be able to get it back together properly. Does anyone have any suggestions or is taking it apart my only recourse?
Thanks in advance for any assistance!
|Oct 08, 2012, 05:40 PM|
plastic parts and some rubber o-rings and seals will not like this.
most likely the engine is frozen due to the oil that was stored in it gumming up the work. heat is your friend. stick it in the oven on about 125 or use a hair dryer or a heat gun on low and see if you can get it to move.
you may also remove the backplate and check the bearings for any rust or corrosion. if the engine sat up in storage for that long i would be surprised if the bearings arent rusted stuck.
|Oct 10, 2012, 12:25 AM|
I would still pull the back plate off to check that the bearing is actually spinning and not the inner race slipping on the crankshaft. This can ruin a perfectly good engine in a short time.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Wanted||Frozen, Worn Out, Crashed Engines||arnard||Aircraft - Fuel - Engines and Accessories (FS/W)||2||Jul 30, 2009 02:59 PM|
|Question||OS .40 engine is frozen after a couple years of sitting||TyFlies||Beginner Training Area (Fuel)||2||Jan 17, 2009 10:04 AM|
|Discussion||Frozen Engines||KOBRA||Engines||6||Jan 17, 2007 04:59 PM|
|.19 Engine frozen up||cnc9130||Engines||4||Mar 17, 2005 09:03 PM|
|Frozen engines||J R Purcell||Fuel Plane Talk||4||Apr 10, 2002 04:20 PM|