|Oct 02, 2012, 01:11 PM|
Advice on working with XDP
I needed to run the XDP program to change the channel mapping on some nano receivers. I had a perceived problem where I thought the XDP program could not see the XDP device.
I have Windows 7. Installed the latest program from XPS (as Administrator) and the drivers installed successfully. Even tried a new usb cable.
Turns out the XDP program was looking for the actual receiver - not the XDP device! It works just fine.
I felt a little foolish, but was relieved to be able to make progress on the project.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion Help. Cannot get started with Flamewheel and DJI||alan2||Multirotor Electronics||8||Sep 05, 2012 07:52 PM|
|Discussion APM2.0 AUTO RETURN HOME SUCCESS! But cannot get position hold. OPEN MY PIDs.||votreami||Multirotor Talk||2||Jun 08, 2012 07:04 AM|
|Help! Cannot get gyro to hold the tail||radarman||Large Electric Helis||0||May 05, 2012 03:37 PM|
|Discussion Cannot get 12v DC output from Delta DPS-700EB||brightfan||Batteries and Chargers||5||Apr 01, 2012 01:06 AM|
|Sold xtremelink device programmer (xdp)||4*60||Aircraft - General - Radio Equipment (FS/W)||2||Apr 18, 2010 03:01 PM|