Crimper Size Question
Sorry guys, I wasn't sure where to post this question. I am looking to buy a crimper than can crimp both the larger female Molex connectors and the smaller female Futaba servo connectors.
The cheapie crimper I have now can do the Futaba servo connectors just fine...
But the notches are far too small for the Molex connector ...
Can anyone educate me on the sizes I should be looking for for these connectors or even better a recommendation on a good crimper? Thanks.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||Sold pending fundsExtension Pin Crimper||joefly||Aircraft - General - Miscellaneous (FS/W)||0||Apr 15, 2015 11:42 AM|
|Discussion||Servo wire crimpers?||golliher||Stone Mountain RC Flyers||15||Mar 15, 2015 08:28 PM|
|Discussion||Cheap(er) Molex PicoBlade Crimpers||CraigHB||Micro Helis||0||Feb 02, 2015 10:57 PM|
|Sold||Anderson PowerPole 15/30/45 amp Crimpers!||oneskinnydave||Aircraft - Electric - Batteries & Chargers (FS/W)||2||Dec 29, 2014 10:57 PM|
|Discussion||Noob question about turnbuckle wrench size.||CptKlink||Electric Power Cars||3||Dec 17, 2014 09:25 AM|