USA, OR, Grants Pass
Joined May 2010
Can a propeller be shortened
I have never heard or read anything on this subject matter before, so maybe it is something that should not be done. I would like to know if a propeller could be cut a little off the tips to better suit an engine requirement and also get better ground clearance.
A little background on why I am asking, I am putting a Mintor 22 cc gas engine on a Four-Star 120 that I am building. The recommended size prop for the Mintor is 17 X 6 to 17 X 8. I happen to have a couple new Top-Flite Power Point 18 X 6 props that I picked up real cheap at an estate sale. I believe I would not have enough ground clearance for my 4 Star with these props. Looking at the props, it would be very easy to take 1/2" off each tip to make them 17" long. They could be balanced afterward. I'll attach a picture of a prop, and where I propose on making a cut. To me that little bit removed from the tips should not effect the properties of the prop very much. Thanks for any opinions and advice.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Bixler v1.1 EPO 1400mm Can wings be transported separately?????||Ron Christensen||Electric Sailplanes||4||Feb 09, 2013 03:24 PM|
|Help!||Can electric servoless retracs be slowed?||Brianlon||Power Systems||27||Jan 22, 2013 02:15 PM|
|Discussion||If there's even one life that can be saved.....||BE77 Pilot||Life, The Universe, and Politics||22||Jan 17, 2013 06:22 PM|
|Discussion||Can strip LEDs be shortened / cut to length?||Downwind3Zero||Dimension Engineering||0||Jun 13, 2010 11:29 AM|
|Discussion||Can wheelbase be shortened?||e.dandrea||Motorcycles||8||May 15, 2009 02:57 PM|