|Jun 02, 2012, 09:00 PM|
Joined Apr 2011
HK Multi Rotor Control Board MIX
Hello guys, i have looked for a long time a firmware that simply just mix the 4 motors ( a XCopter ) and don't use the 3 gyro of the board.
I want do it because i want to try the flymentor 3D that actually is simple waiting for my hely to be rebuild and also because it could be usefull for making video on a steady position.
Or i just need to know how to mod the firmware of the base xcopter to leave out its own gyro.
Thanks for helping
|Jun 02, 2012, 11:23 PM|
dunno why you'd ever attempt this, but it'd be pretty easy to do it on the TX for a + orientation.
you could set all four ESC channels to the throttle stick, and then split pitch/roll for the four motors into each channel, respectively. so, if you pushed pitch up from center(go forward) it would give the rear more power(maybe reduce front too?).
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Help with HobbyKing Multi-Rotor Control Board V2.1 (Atmega168PA)||rpscarlets2294||Multirotor Talk||3||Nov 04, 2013 02:29 AM|
|Hobbyking kk v2.1 multi rotor control board||penz83||Aircraft - Electric - Multirotor (FS/W)||2||May 22, 2012 09:27 PM|
|Help!||need help with programming the hk multi rotor board||cheechmymarin||Multirotor Talk||2||May 07, 2012 11:26 PM|
|Question||Quad Build Using HobbyKing Multi-Rotor Control Board V3.0 (Atmega328 PA)||SJackson||Multirotor Talk||27||Apr 30, 2012 09:51 PM|
|Discussion||HK Multi-Rotor Control Board||animan9||Multirotor Talk||1||Jan 31, 2012 01:49 PM|