|Feb 23, 2012, 12:51 AM|
Joined Oct 2009
exceed monster 32 prop mount
i have 2 exceed monster 32 motors on my deuces wild and one came with a bent prop mount that causes a nasty vibration making the plane a basement decoration. does anyone know where i can find the mount or even a whole motor with one, no one has any instock and it doesnt look like they will soon.
|Feb 23, 2012, 05:26 AM|
Exceed Monster 32 has a 5mm shaft.
Would a 5mm prop shaft adapter be what you need?
|Feb 23, 2012, 01:09 PM|
As long as the shaft isstraightm you have tow options - both involve collet or set screw prop adapters:
1) If you can, turn the motors around and mount them on the other side of the fire wall. Then put a prop adapter on the sharft sticking out the new fron of the motor. If the plane is already built, this is probably not an option, but you might be able to use a motor mount that will let you accomplish the same thing, but leave the motor in the same place.
2) Push the motor shaft out the front of the motor. Pull the wheel collar off the back and any snap rings. Then pull the whole bell and shaft out the front of the motor. Loosen the set screws attaching the bell to the shaft and remount the bell with the shaft sticking out the front. IIRC, the bell is a tight fit on the shaft and you'll need to use a press to get it out.
Another way of doing this would be to leave the motor assembled, but pull collar and retaining rings off the back of the shaft. IIRC, there's a groove at the back end of the shaft - install the snap ring into this groove, loosen the bell's set screws and press the shaft out until the snap ring is flush with the rear bearing.
Either way you get it there, you put a prop adapter on the shaft sticking of of the fron of the motor. You may need to adjust the spacers to get the right placement relative to the front of the plane.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wanted WTB prop mount for exceed monster 32||schnitzelwagen||Aircraft - Electric - Power Systems (FS/W)||2||Feb 19, 2012 08:29 AM|
|Discussion Help need a prop adapter for an Exceed Monster Power 15||luigirox||Electric Motor Design and Construction||6||Oct 14, 2011 08:09 PM|
|Wanted prop adapter for exceed rc monster 32||schnitzelwagen||Aircraft - Electric - Power Systems (FS/W)||0||May 18, 2011 12:01 AM|
|Sold Exceed RC Monster Power 32 NIB||snoshoe62||Aircraft - Electric - Power Systems (FS/W)||5||Jun 28, 2010 06:23 AM|
|Wanted eflite power 32/ Exceed monster power 32||turbored21||Aircraft - Electric - Power Systems (FS/W)||6||May 29, 2010 12:37 AM|