|Aug 14, 2012, 03:16 AM|
Death of another camera
The TCM8240 was finally voted off the island, when it showed a sporatic short circuit which caused the CPU to die. Maybe that was making it fail to output raw data.
The closest it came to outputing anything was using the registers found on:
It only produced a completely white picture. Maybe the chip was defective. Maybe the pinout had an error. It doesn't matter, since it never encoded JPEG & there is a much smaller camera which can output raw.
Also remembered 1 way to simplify the routing & shrink the board is to connect the data pins out of order, then use a software lookup table to reorder the bits. Who knows how slow that would be. A speed test on the revision 1 board would reveal the impact, but be a lot of work.
The PWM signals are being generated. The IMU is being read & fused. Time to put it on the airframe.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion The life and death of another plank||atjurhs||Slope||5||Dec 20, 2007 01:25 PM|
|Discussion Another lipo storage death?||brodjack||Batteries and Chargers||6||Mar 09, 2006 10:07 PM|
|Another Dandy trial, another dive to it's death. :(||Skawrpion||Parkflyers||32||Sep 29, 2003 09:20 PM|
|Another case of premature HECell death||BEC||Batteries and Chargers||10||Mar 20, 2003 03:59 PM|