|Jan 19, 2010, 08:24 PM|
Question on Binding w/DX6i
Just recieved my DX6i, I am feeling a little foolish in asking how to Bind the AR6200 to the transmitter. The instructions are extremley vague and the photo is very poor. Can I plug my ESC/with battery into throttle slot on RX and then the Bind plug into Bat/Bind slot and get the same result?
On top of the vague set up instructions, the supplied Bind Plug doesnt even fit into the receiver. No problem its just a jumper I can overcome that little bit. Thanks.
|Jan 19, 2010, 08:57 PM|
Yes, you can power the receiver through any servo port.
Flip the bind plug over, they sometimes fit better one way than the other.
|Jan 19, 2010, 09:03 PM|
Note that the bind plug has bevelled corners on one side. Since polarity doesn't matter, I like to bevel the other corners as well so I don't have to worry.
The fit of plugs into the AR6200 and some other receivers is tight. I find it necessary sometimes to sand the plugs very lightly and in particular to bevel the end very slightly so it goes in more easily.
The instructions should be improved and should cover the most common set up -- the one you describe.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||I'm binding, but not flying...Blade MSR on the DX6i||Hostage-46||Beginner Training Area (Heli-Electric)||6||Jan 16, 2010 07:43 PM|
|Discussion||Spektrum DX6i - Timer question (Can't turn it on!)||maxwolfie||Radios||10||Nov 20, 2009 06:39 AM|
|Discussion||Binding to a Dx6i||cgage||Beginner Training Area (Aircraft-Electric)||3||Sep 21, 2009 03:04 PM|
|Discussion||Spektrum DX6i....Binding multiple planes to same model slot||mondo1948||Radios||6||Sep 10, 2009 12:46 PM|
|Discussion||Help please - trouble binding DX6i to MSR||vhawk12||Radios||5||Sep 04, 2009 11:39 AM|