The output voltage to the 130 servos is only 3.7 volts.
The 180 are rated at 6 volts.
I would say you would have to run a seprate ESC controlled by the 3 in 1 to power the servos and the 3s motor. This could be done with the Talon by connection the signal wire from the ESC to a signal point on the 3 in 1.
Probably will not pirouette worth crap because the 130 board sucks big time, no piro compensation.
The second issue I see is the servo layout is backwards, the elevator is on the rear of the 130, on the front of the 180.
The 130 board would have to be mounted 180°, servo connectors towards the rear of the 180.
Would be a neat project, but is it worth the time involved?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Calidus RC fly with flight controller(picture in picture control video )||LOUIS HU||Auto Gyros||11||Apr 08, 2015 05:46 AM|
|Discussion||using brushless gimbal controller as a multiwii flight controller||moophus||Scratchbuilt Multirotors||2||Mar 25, 2015 04:46 PM|
|Sold||Two eflite red bull 130 one used one new in box four batts||jdakrt||Aircraft - Electric - Helis (FS/W)||2||Feb 14, 2015 06:23 PM|
|For Sale||Blade 130 Fbl 3-in-1 Control Unit,RX/ESC/Gyros||mike p de l||Aircraft - Electric - Helis (FS/W)||0||Aug 11, 2014 05:01 PM|
|Sold||Tarot T-2D 130.00 buyer pays shipping new in box never used||Bugsbunnyheli||FPV Equipment (FS/W)||6||Feb 23, 2014 02:08 PM|