Originally Posted by richard hanson
My own procedure - is to enter bind -holding switch/button etc., till i see a reading on the screen (on screen equipped radios) noting the bind is complete.
On non screen models of tx - I just watch the rx till the flash stops then let go the switch.
which or what other visual aid do you think is best?
This proceedure may end up with the failsafe reverting to default which is fine unless the throttle servo is reversed in the model. If the throttle servo is reversed in the model default failsafe will result in wide open throttle. That is what started this post. release the switch as soon as bind mode starts.