|Oct 03, 2012, 10:38 PM|
Wichita, Kansas, USA
Joined Jul 2003
I want to use some 1 watt LEDs for nav lights. The LEDs run on 3.0 - 3.2V and a constant 300 to 350 mah to make the last longer. Do I need a driver for these LEDs or can I simply use a resistor to drop the voltage? I'm slightly "electronically challenged" so any info would be greatly appreciated!
|Oct 04, 2012, 10:11 AM|
Joined Nov 2003
A resistor is ok if running off one lithium cell, but if running on 12V, a buck convertor is
in order. National semi, LTC, Maxim, others have them. Switching step down regulator.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Flexible little LED Driver for 1W LEDs||KTMRacr||Night Flying||2||Aug 12, 2012 11:45 PM|
|Discussion||LED Driver discovery for 1-W LEDs||barb wire||Night Flying||0||Sep 14, 2010 06:18 PM|
|Discussion||34063 switcher as high-power LED driver||flieslikeabeagle||DIY Electronics||12||May 04, 2009 01:27 AM|
|Help!||PWM & LED driver||rocky79||DIY Electronics||23||Sep 05, 2007 06:07 PM|
|Mini-HowTo||Constant Current LED Driver for 2s li-po and above||z-matrix||DIY Electronics||2||Nov 06, 2006 02:16 PM|