|Apr 07, 2014, 02:51 PM|
Pulse on battery power
On a YEP 100 amp I am seeing a pulse on the battery terminals that is just about the same rate as the timing set on the controller.
At first I thought I was seeing the FET switching then since it was similar with the clock pulse , this could be what I am seeing. The pulse stays at the same frequency during acceleration but the amplitude changes from about 1 v p-p to about 2v p-p.
Could this be just a problem with one phase?
|Apr 07, 2014, 05:02 PM|
It just seemed odd that I would see this waveform on the battery side.
I was looking to see if there was a noise problem with these ESC's. I seen this and the next to see if there is a filtration problem with the controller voltage rails. It just seemed odd that I would see this waveform on the battery with some extra .1uF caps installed.
Bruce could you check out to see if I am getting it right on the YEP 150's http://www.rcgroups.com/forums/showp...&postcount=193. report 193 to 250
|Apr 08, 2014, 01:19 AM|
In the other thread you say that your setup can exceed 150A static. Your scope image is too small to see clearly, but the waveform appears to show a step of about 0.5V on the rising and falling edges. Your ESC has two Rubycon ZLH 470uF 35V smoothing cps, right? If you were running part throttle and the motor current was 50A, then each cap was passing ~25A peak and must have an ESR of about 20 milliohms (0.5V/25A).
According their specs those caps have a maximum ESR of 28 milliohms, so it would seem that they are working correctly. To reduce the ripple voltage you simply need to add more caps.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Need Advice on Selecting Battery for Charger Power Supply!||myerss17||Batteries and Chargers||8||Jul 24, 2014 01:56 AM|
|Discussion||KK2.1 powers on w/ battery, not ESC???||LawyerFrank||Multirotor Talk||9||Feb 04, 2014 03:44 PM|
|Discussion||Blade cx2 Looses power after one minute on 5 batteries all fully charged||cadcyg||Coaxial Helicopters||4||Oct 06, 2013 09:03 PM|
|Discussion||Low power on bigger C battery?||cvianna||Multirotor Power Systems||1||Sep 24, 2013 04:43 AM|
|Pul Pull On Scratch Built, Any ideas?||Gonflyin01||Parkflyers||1||Jan 23, 2002 03:12 PM|