|Sep 11, 2013, 03:54 PM|
flaps and dual servo elevator on a dx6i?
hey there, I know this is not the radio forum but I am getting ready to post a build log and the scratchbuilt people seem very helpful with everything. so that being said, I have a dx6i with a 6ch rx, I have a plnae I am building that has ailerons,flaps,rudder, and dual servo elevator. so is there a way I can do this on the dx6i with out a y-lead? the problem I have is when I set it up in a mix to the gear channel it listens to the gear switch too and and when I switch the gear switch it goes to the side but still listens to elevator. how can I dsable the gear switch? or is there a better way to do this? any help would be gretlly appreciated. thanks
|Sep 11, 2013, 04:05 PM|
Won't you run out of channels, or are you running only one aileron servo?
Here are some solutions:
|Sep 11, 2013, 04:11 PM|
i am using a y-lead for the ailerons,a y-lead for the flaps but am out of y-leads long enough for the elevator. So that is what i am figuring out.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Can't figure out dual aileron and dual elevator servos||MUDDOBBER||Foamy EDFs||14||Sep 03, 2013 09:28 PM|
|Discussion||F22 Setup up For Dual Ailerons and Dual Elevators on a Specktrum DX8||chitwood||Radios||17||Jul 13, 2013 05:14 PM|
|Question||Need tips on flap elevator mix on P-47||duker733||Electric Plane Talk||14||Feb 07, 2013 12:32 PM|
|Discussion||DX6I Dual Ele And Dual AILE servo setup ?||metalwizard||Radios||18||Jan 24, 2013 09:04 AM|
|Discussion||DX6i and dual elevator servos for 3DHS 55" SHP||finchkid24||3D Flying||5||Oct 26, 2010 12:42 PM|