|Nov 26, 2013, 05:43 PM|
|Dec 02, 2013, 04:11 PM|
Ergo working file .dxf
Enclosed is a working file for the Ergo, it is not structured or in any format or sheet just a raw dxf file for anyone to work with should they like to try and build one of these speed demons. You may need to adjust the cage diameter for your housing, Gary has a couple of nacelles as does Velocity-RC. I'm thinking of building a plug for a nice 70mm nacelle and 90mm nacelle following Clauses lead in design but with my twist of a straight cylinder area before and after the fan, in other words I extended the front of the housing by 12% and the rear by 75% shrouding the motor and to facilitate and area of even/equal velocity before it squeezes in the tail pipe efflux. I made quick change tail pipes using g-10 rings taped to the rear extension until I found the one I liked.
The cats out of the bag as to why its so quiet and works more efficient than other CS70 mm fans.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||How to find CG on a Delta wing?||mikes68charger||Scratchbuilt EDFs||33||Apr 24, 2014 02:10 PM|
|Question||flight-test-adjusting CG for speed on flying wing sloper||Joe the Stack||Flying Wings||4||May 26, 2013 01:58 AM|
|Discussion||Why on earth do my plans say to set CG with the wing off?||CNY_Dave||Electric Plane Talk||4||Jan 20, 2013 05:37 PM|
|Question||On a full size/scale aircraft what are the mini nacelle looking things on the wing?||billiam2536||Modeling Science||5||Apr 28, 2008 02:50 PM|
|Where should the CG be on my new thing? Check out the pics.||Sammy B||Scratchbuilt Indoor and Micro Models||1||Nov 07, 2004 08:17 PM|