|Jan 19, 2013, 10:42 PM|
Joined Jan 2013
Help, Lipo Battery wont seem to charge up all the way
Hi, I have only had 4 flights on my new 11.1v 1100Mah lipo, and Ive had it on the charger for 2 hrs and it is only going up to around 10.75. It is a cheap FMS balance charger but it went up to full charge in an hour before. Also, It only ran down to about 10 on my last flight before losing so much power that it wouldnt take off. I am new to lipos so any input would be greatly appreciated. Thanks!
|Jan 20, 2013, 12:33 AM|
USA, MO, Florissant
Joined Nov 2010
Sounds to me like you over-discharged the battery. While loaded, 10V may be OK, depending on how much current the load represents, but if that was the voltage after is was unplugged a while, then it was too low. Have you measured the voltage of each cell? I suspect you'll find one is lower than the rest.
|Jan 20, 2013, 04:02 AM|
Sverige, Värmlands Län, Filipstad
Joined Jan 2009
If one or more cell goes "bad" an indication of that is that it takes long time to get the battery pack fully (balanced) charged. The bad cell(s) will strugle to reach 4.20 volt (=fully charged). I have experienced this myself. I would guess that most common cause for this (exept the battery had many cycles on it) is that a battery has been run down to almost empty. Always leave about 20% of capacity in the battery when flying, the absolute minimum 10%. Otherwise the LiPo pack may get a shorter life then it otherwise will have. Another good thing is to storage charge the Lipo to 50-60% if capacity when You do not intend to use the battery for maybe a week (to have them fully charged ready for useage will be OK for a day or two).
Although balance charging is prefered You do not need to do that every time at the field (if You charge at the field). It goes faster to charge. You can set in many charger that it will end charging when it is charged to for example 95% - the last 5% usually takes long since then the balancing is working most at the end of charging process. But balance charge as often as it is practical possible to get all cells fully charged to 4.20 volt.
|Jan 20, 2013, 06:54 AM|
Also so far most of the suggestions you have received prior to this are based on an "if" as in "if a cell is low".
You really need to replace your charger with one that removes the "if" and provides you with the information you need. For example:
This charger will provide you with the:
Individual cell voltages
Milliamps returned to the pack
There are cheaper chargers available but this is a good one for starters.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion Gonna charge up some six year old lipos||cloud_9||Batteries and Chargers||15||Jan 12, 2013 12:12 PM|
|Sold Large LiPo Battery Charging & Storage Bag -$9 shipped||jarih||Aircraft - Electric - Batteries & Chargers (FS/W)||2||Jan 08, 2013 01:17 AM|
|Question lipo wont charge up||foamyflier||Batteries and Chargers||4||Aug 27, 2007 07:09 PM|
|I can't seem to push the CX battery all the way in||ktmrider||Coaxial Helicopters||2||Dec 13, 2005 04:24 PM|
|Do you run batteries all the way down after each charge?||gassyanimal||Parkflyers||6||Jun 20, 2001 05:46 AM|