|Oct 12, 2011, 07:17 AM|
Replacement shaft help
I just got done winding a MiniGBx kit, 22 turns, 28 gauge (just like the MicroDan motor). Anyway, its pulling the bell off the stator when I run it up. I kinda figured this would be a problem even before I wound the motor so I emailed Dan and he said on customers motors he puts a drop of CA at the end but on his personal motors he leaves it free. So now I'm on the hunt for a 1.5mm shaft atleast 34mm in length that will accept an e-clip. There's no way I want to put CA that close to a bearing and I don't have any cut off disks small enough to make a cut for an e-clip...
So does anyone know of a replacement shaft that will work or other suggestions?
|Oct 12, 2011, 10:37 AM|
You might have to make your own shaft. A good material for that would be a 1.5mm drill blank. That is finished to the tolerances needed and it will be hard enough and ready to use (except for cutting to length and the like) as you buy it.
Here is one typical drill blank and a source for it:
Here is a thread that shows how to do the work:
As a warning, MSC is accustomed to dealing with the manufacturing industry, they are not a hobby shop. The shipping costs on one shaft may be way out of proportion to what you would expect to pay for one small item simply because they ship by UPS or FedEx and not USPS.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||MSC Prop Shaft Replacement||Tricky Tris||Beginner Training Area (Aircraft-Electric)||5||Oct 31, 2011 03:12 PM|
|Discussion||Turnigy G15 replacement shaft and bearings?||JoeR||Power Systems||3||Oct 10, 2011 11:46 PM|
|Help!||E-flite PNP 450 shaft replacement||TravisNeedham||Power Systems||14||Sep 24, 2011 05:42 PM|
|Discussion||replacement shaft TP 3520-7||mackey||Electric Motor Design and Construction||2||Sep 11, 2011 02:19 PM|