|Dec 16, 2014, 12:25 AM|
Joined Nov 2003
X4 Lipo disharge voltage
I have been playing with the Hitec X4. The discharge feature for Lipos is set at 3 .0 volts per cell. Is there a way to change this to a higher voltage? I notice the 2 cell battery actually goes to LESS than 6 volts, something like 5.89 volts. I would like to change the cutoff to 3.2 volts per cell to not overdishharge the battery.
This may require a firmware change. Don't think there are any user adjustments for this.
John in Kalifornia
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||Lipo voltage checker with settable low voltage alarm||kylejclaflin||Aircraft - Electric - Batteries & Chargers (FS/W)||17||Apr 07, 2014 12:04 PM|
|Discussion||Lipo rated voltage good ending voltage?||venton||Batteries and Chargers||2||Jan 15, 2014 05:40 AM|
|Discussion||What disharge size lipo for rx and servos?||sportflyer||Batteries and Chargers||2||Jul 27, 2009 09:59 PM|
|shulze and lipo disharge question||NCguy||Batteries and Chargers||10||Sep 28, 2005 09:58 PM|