|Feb 05, 2013, 05:08 PM|
United States, MI, Chesterfield
Joined Apr 2011
What is considered to be the normal range of reistance on a Lipo pack?
What would be the upper limit of being safe and usable?
|Feb 05, 2013, 06:45 PM|
For instance, if your application has a low current draw power system, a lipo with a high IR will work fine. However, if the system draws high currents, low IR's are necessary.
This thread will give you a program for calculating the true C-rate of your pack based on it's IR and capacity. http://www.rcgroups.com/forums/showthread.php?t=1577989
|Feb 05, 2013, 07:17 PM|
Joined Feb 2001
That depends on the battery size. I’m not sure but I think it’s proportional to the MAH capacity (if 5000 is 2 mohms than a 2500 would be 4 mohms).
Most of my large packs (5000 +) are in the 1 to 3 range when new. High C tends to have lower IR when new. I always record new IR for each pack when new. If the highest cell gets double of the low cell or 3 times the new IR than its time to toss the pack.
My smaller 2200 packs are typically in the 3 to 6 range. These are not expensive packs.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Thunder Power 65C lipo with very high resistence||malcolmm||Batteries and Chargers||3||Jan 31, 2013 07:14 PM|
|Discussion||S108 remote throttle resistance tip||Jay_ombie||Coaxial Helicopters||1||Jan 13, 2013 04:07 PM|
|Discussion||Measuring winding resistance||Nereth||Electric Motor Design and Construction||9||Jan 07, 2013 07:03 PM|
|Discussion||RMRC VTX low resistance||gil_mor||FPV Talk||2||Jan 07, 2013 12:45 AM|
|Internal Resistance of LiPo Cells?||FlyingW||Batteries and Chargers||0||Jul 30, 2003 09:35 AM|