|Jun 23, 2012, 12:57 PM|
Hot wire melting of about 24 chunks of EPS.
Then glueing together.
I made a 3D model of the plane, and printed a bunch of corresponding cross sections.
These templates are cut with a knife, and glued of the front and back end of a eps chunk.
Then i pull the hot wire against the templates, by doing this i have both the outer and inner construction and design.
Take a look at my blog, it explains itself pretty much.
|Thread||Thread Starter||Forum||Replies||Last Post|
|For Sale K&A models Mig-15||totenkopf||Aircraft - Electric - Jets (FS/W)||5||Jul 01, 2012 10:20 AM|
|Sold Banaga Hobby Mig 15||Grandstand||Aircraft - Electric - Jets (FS/W)||8||Jun 23, 2012 12:00 PM|
|Discussion KA Models Mig 15 vs. Alfa Mig 15||Tram||Electric Ducted Fan Jet Talk||11||Jun 20, 2007 03:51 AM|
|Sold Kamdax Mig-15 EDF & Kamdax Mig-15 Pusher Jets||Yardbee||Aircraft - Electric - Jets (FS/W)||6||Nov 26, 2006 09:40 PM|
|gws a-10 or k&a micro/alfa mig 15 or kamdax mig 15||FlyinAg||Electric Ducted Fan Jet Talk||1||May 07, 2005 01:24 PM|