HobbyKing.com New Products Flash Sale
Reply
Thread Tools
This thread is privately moderated by nom, who may elect to delete unwanted replies.
Old Oct 26, 2011, 11:31 PM
nom
Registered User
nom's Avatar
United States, ID, Boise
Joined Mar 2011
1,490 Posts
Discussion
Parkzone Wildcat Repair - Finally Done

Well I worked hard to think about how to fix the firewall on the fuse and just picked up some cull wood at Home Depot for less than a buck and made a firewall from it. Used the old screw slots on the left side and drilled some holes on the right, the screws on the right I dipped in epoxy and hope it'll hold. I also had to epoxy the right wing since it tore off from the fuse and also picked up a new aluminum wing rod/bar since the old carbon one broke in the middle inside the fuse. Glued back both plastic wing brackets where the foam attaches to the wing since they became lose in the crash. All in all it looks good to go and will test it out tomorrow.
nom is online now Find More Posts by nom
Reply With Quote
Sign up now
to remove ads between posts
Reply

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Hemmens caton V4 finally done Deserteagle Steam Boats 7 Sep 27, 2011 09:22 PM
Alert Vector2's are finally done! Ready for sale! davekra Slope 0 Aug 13, 2011 09:41 PM