|Feb 04, 2014, 04:40 AM|
Joined Feb 2014
Santa Maria Parts Identification
Can anyone help on identifying a particular part in the Santa Maria - Artesania Latina? I have completed the hull and decking etc. and am at the rudder (going according to the instructions) but the brass pieces for the rudeder are confusing. There are said to be 3 and I find 4 but more than that, the piece that would seem correct is such a solid piece of brass with quite extensive turning done to it that it doesn't seem logical that one would have to cut these pieces down. I have searched every inch of the internet to make certain of the identification of this piece but find nothing conclusive. As there is no other brass piece that it could possibly be, it seems that this elaborate piece of brass must be it - yet, it doesn't really make sense. Can anyone help?
Thanks so much,
|Feb 08, 2014, 01:32 PM|
I haven't built that kit, and I don't know if anyone else here has. But we may be able to help if you can post some pictures of the parts in question.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Latina "Santa Maria"||P. Tritle||Scale Boats||48||Jun 29, 2011 03:34 PM|
|Where to fly in Santa Maria, CA||ktoey||Slope||45||Jun 05, 2009 10:55 PM|
|For Sale||Santa Maria||flyer66||Boats (FS/W)||0||Jan 17, 2006 07:03 AM|
|Flying in Santa Maria/Pismo area!||Doostin||Slope||3||Aug 15, 2003 10:46 AM|
|E-Flight in SANTA YNEZ/SANTA MARIA/CAL||Armin Mangelmann||Electric Plane Talk||0||Jun 16, 2001 04:30 PM|