|Jul 09, 2014, 05:19 PM|
Sounds like you may have fried the voltage regulator in the ESC. I would first check if you are getting any voltage on the red and black wire on the servo connector with a volt meter. If you get 5v then its probably your RX is bad, if you dont get any voltage, your ESC or maybe just the BEC is fried. try powering RX with an external BEC then.
Or maybe your RX is bad. try it with a verified good ESC.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Found||forget the plush, i need 5x 30 amp esc that i can flash, no plush !!!||crash8384||Aircraft - Electric - Multirotor (FS/W)||14||Jun 25, 2012 04:10 AM|
|Discussion||is it possible to flash the Flycam Blackboard w/ 4.7kk X||betito||Multirotor Talk||2||May 03, 2012 03:12 PM|
|Discussion||Silabs 8051 ESC (Turnigy Subperbrain) Firmware||nickax||Multirotor Talk||2||Jan 30, 2012 12:11 AM|
|Sold||2 Turnigy Plush 10 amp ESCs + 1 Turnigy 5A UBEC + 1 Turnigy Programming Card - $21||shawn595||Aircraft - Electric - Power Systems (FS/W)||2||Apr 02, 2011 01:30 PM|
|Discussion||Is it possible to convert TURNIGY Plush 30A ESC's from PWM to TWI/I2C control||benbois||DIY Electronics||0||Dec 17, 2008 12:56 PM|