|Nov 30, 2012, 05:04 PM|
Arduino Based CL Timer for Speed
Hi Everyone !
I want to show you my DIY - Timer made of an Arduino Nano Board.
Still in development, but it already works a bit.
It is designed for Speed Applications, but with other software it would be possible to use it for everything else.
Flight time in the Video is shortened for testing.
The LED means :
Red - Akku connected
Yellow - initialising of the controller (blink) and accelerating or braking (steady)
Green - Full Throttle (steady) end of flight (blink)
Weight is 17g.
It is planned that the accelaration stops at a adjustable throttle to grab the speed pole and place the fork for a time.after that it will go to full throttle, like a reso would do after whipping. It is already programmed but yet not tested.
You can adjust :
amount of accelaration ( that you have a softer start)
Plateau speed ( plateau means the "reso" imitation)
It`s missing the start switch, have to buy one first. It is possible to connect it to the bellcrank as a shutoff.
Here is the link to the video :
Oh, battery was weak, so it didn`t reach top RPM`s.
Best regards and ever tight lines ,
|Dec 03, 2012, 10:19 AM|
Hi Everyone !
Here is the code.
Have much fun building !
It would be wise to add a additional switch to prevent the motor from accidental running.
The code is the Version with the "plateau" . It is now tested and runs fine.
Change the file extension from .txt to .ino, then it will work
|Jan 07, 2013, 11:15 AM|
New Hardware update !
No potis anymore and just one RGB LED. But now i have extra a button to start the engine besides the Main switch. Main Switch also acts as a energy shutoff, when linked to the bellcrank.
Pen is for size comparison .. .. ?..
Now much better for installation.
Have to do the Software now.
Best Regards, Sebastian
|Jun 26, 2014, 03:50 PM|
I'm very interested in your arduino based timer, i want to develop my own timer for F2B.
I'm a a newbie in arduino projects, but i want to build my own timer and i will buy a arduino nano board.
I think your code is the same that i need to F2B timer.. i need to control the speed, the time and one switch to start. I think in other functions like a delay between the start button and start engine, in order to have time to run to the handle. Other function may be a signal before engine stop.
Thanks for your code, i will try to start.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Arduino based IR tag module for combat||sh4nce||Electric Combat||36||Aug 19, 2014 03:21 AM|
|Help!||Engineering student and first arduino based build?||cad2blender||UAV - Unmanned Aerial Vehicles||3||May 17, 2012 07:59 AM|
|Discussion||What are the Orange Rx pin configuration for a Arduino based quad?||Drone Reasearch||Multirotor Talk||6||Jan 24, 2012 09:04 PM|
|Discussion||Wrist Mounted Ultrasound Arduino Based Sonar for the Blind||rcgroupie||DIY Electronics||2||Aug 24, 2011 01:25 PM|