|Aug 23, 2010, 05:45 PM|
4G6 ESC getting too hot?
A few weeks ago the motor went out in my 4#6S. Instead of buying a new stock one for it I took the black TurboAce out of my 4G6 and then bought an HP07-2 for it. After installing it I discovered it had a bad cogging issue. I did some reading and found that they recommend using the ESC from a CB100, instead of the stock one, when using this motor. I happened to have an extra CB100 ESC lying around so I threw it in there. The cogging went away so I thought all was good.
However now I think the ESC might be getting too hot. I've only flown it maybe a 1/2 dozen times since putting in the new motor, but I just noticed that the clear plastic around the ESC has shrunk so much that it actually split at one of the corners and the yellow plastic sleeve around the RX is rippled slightly on the side the ESC is stuck to. It doesn't feel hot to the touch, even right after a flight, but the signs point to it getting pretty hot during flight.
Is this normal? Is it something I should worry about?
|Aug 23, 2010, 08:18 PM|
My esc ran HOT also. It shrunk the heat shrink on the esc like yours is doing.
It is the L2 CB100 esc.
It's best to remove the heat shrink from the esc and it will run cooler. Don't mount it
directly to the RX. It will melt the yellow heat shrink housing as I found out.
The HP07-2 motor is an amp hog and will make you esc run hot.
My canopy was even very warm due to the heat from the HP07-2 and esc.
Not to mention the battery was very warm and the battery connector
The motor and esc combo produces a lot of heat but runs fine.
No problems yet.
|Aug 24, 2010, 06:28 AM|
Also mount the 6 FET's up so they run cooler. Mounting them down
will reduce the air getting to them and they will run hotter.
A heat sink would be good to keep it cooler like Timewerx said.
I want to try it. A small piece of aluminum with thermal tape attached
to the 6 FET's should work great.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||How hot is too hot for my 85A ESC?||717||Power Systems||7||Aug 20, 2010 07:18 PM|
|Rant||Too Hot to Fly||RC Man||Electric Heli Talk||27||Jul 26, 2010 09:12 PM|
|Discussion||How hot is too hot for the ESC and Brushless motor?||JLH Racing||Car Talk||85||May 31, 2010 10:21 PM|
|Discussion||Cularis ESC getting HOT! Need Help.||outngo||Power Systems||13||Sep 12, 2009 06:01 PM|
|Discussion||Esc Getting Way Too Hot||jim florentine||Flying Wings||4||Aug 05, 2009 11:50 PM|