|Oct 14, 2010, 02:00 PM|
United States, NY, Endicott
Joined Jun 2006
Source for Carbon Fiber, Aluminum, and Cardboard Tubes
I'm going to build a vintage kit of an aerobatic biplane that was designed in 1973. The wing span is 55". As with many larger wings of this time period, they are built in two halves, and then glued together in the center. Then you have to add a 4" wide strip of fiberglass or polyester tape over the center section to give it adequate strength.
I don't want to use the tape. I'd like to use carbon fiber or aluminum tubes in the wings as spars, kind of like the newer ARFs do that have larger wings. This makes for a neater covering job without the bulge of the tape on the center section. It also would allow me to take the two wing halves apart for easier transportation.
Does anyone know of a source for the carbon fiber and aluminum tubes, and also the cardboard or fiber tubes that are permanently installed in the wing panels to receive the spar tubes?
Thanks in advance.
|Oct 14, 2010, 05:24 PM|
Take a look at McMaster-Carr
I have used this place as a source for years.
Another place for finding certain items is www.smallparts.com
They both stock lots of items that you just can't find at the local
hobby shop. The downside - They are Industrial supply houses.
The shortest length of tubing is usually 6 ft.
The tubing is shipped inside a large cardboard tube.
That can get expensive.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||CX2 carbon fiber and aluminum||Fastleft||Aircraft - Electric - Helis (FS/W)||1||Oct 09, 2010 06:11 PM|
|Found||Carbon Fiber tubes 196 OD x .121 ID x 24||wbrannies||Aircraft - General - Miscellaneous (FS/W)||5||Sep 24, 2010 11:47 PM|
|Discussion||Carbon Fiber Rods/Tubes||rr9434||Coaxial Helicopters||3||Aug 31, 2010 11:54 PM|
|Need a good source for carbon fiber tubes||gunnisonflyer||Vendor Talk||3||Dec 01, 2003 12:06 PM|
|WTB/ Source for 1/8 carbon fiber tubes for fanfold 3d's||pval3||Aircraft - Electric - Airplanes (FS/W)||9||Nov 15, 2003 05:45 PM|