|Oct 13, 2012, 12:10 PM|
Painting and more
I have a FMS 1400 T-28 that I'm replacing the flap and aileron servos and had an idea. I donít know if itís a new idea or a tried and tested idea, but what I was wanted to do is after I replace the servos instead of re-taping over the wires in the cut out channel glue them down and put some lightweight spackling, sand and repaint. Which leads me to my question, from what Iíve found by searching is, Krylon Fusion is the paint I should pick up for this project.
Also I seen somewhere in a thread (can't remember where) a little wheel tool that if you run along the EPO it makes it look like rivets on the skin, any idea where I can pick something like that up?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||Scale Parts / Brushless Tekin / Lipos / Servos / Paint + More --PICS--||SoCalSteve72||Cars - Trucks and Parts (FS/W)||0||Sep 26, 2012 07:26 PM|