|Jun 07, 2010, 03:43 AM|
My KX-131 dead :(
I was working on my fpv setup and inserted the 3 pin pluc into back of my KX-131 camera. The connector seemed loose and not right. So i took the back off and found the connector has come away off the pcb.
I de soldlered it and this is what ive found underneath, it has stripped the conductors off the pcb so i can solder it back on or solder wires to it as the conductors have gone :
Does anyone know of anyway around this, like plis etc i could take my wires to instead or is it a right off ?
|Jun 07, 2010, 07:43 AM|
Use a magnifying glass & follow the tracks back to other components & solder your wires directly.
It may involve micro-surgery but if it works make sure you anchor the wires securely via hot melt glue of it wont last 5 mins.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||kx-171 or kx-131 for daytime flying?||lovegroove||FPV Talk||16||May 30, 2010 05:34 PM|
|Discussion||KX 131 Camera Resolution?||lilphil26||FPV Talk||3||Mar 05, 2010 09:39 AM|
|Discussion||KX-131 Connectors||scrtsqrl||FPV Talk||2||Oct 26, 2009 05:03 PM|
|Wanted||Camera Kx-131 or sn480||dmondong||Aircraft - General - Miscellaneous (FS/W)||1||Aug 31, 2009 11:42 PM|
|New Product||KX-131 CCD. Cased and uncased. 12volt and 5 volt.||reznikvova||Aircraft - General - Miscellaneous (FS/W)||18||Oct 12, 2006 01:36 PM|