Joined Apr 2012
Change pin used for motor in MultiWii code
Hello everyone. I have a promini 328P board. The promini is supposed to be able to control 6 motors, for a hexacopter.
I have recently managed to fry (it would seem) pin nr.3, so it can no longer control an esc.
Since I am trying to run a quad, I hope I correctly assume that I am left with two usable pins on the board, which could be used as a replacement for pin nr.3.
The only thread I found on this subject is this one http://www.multiwii.com/forum/viewtopic.php?f=8&t=1382
I tried the advice from that thread, but it did not work.
How can I change the code to use pin nr. 5 or 6 (or perhaps A1 or A2??) instead of pin 3?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Careful!||Warning! rabbit Flight Controller uses stolen code from MultiWii||hamburger||Multirotor Electronics||1107||Sep 15, 2012 08:00 PM|
|Discussion||Changing CAMSTAB pin out on MWC mega||Foam boy||Multirotor Electronics||0||Aug 07, 2012 12:54 AM|
|Discussion||Two changes to the tax code that would significantly change politics ...||logan5||Life, The Universe, and Politics||23||Apr 12, 2012 02:57 PM|
|Discussion||Calibrating ESC's using multiwii code||mstanescu||Multirotor Talk||0||Mar 11, 2011 02:37 AM|