View Single Post
Old Jun 05, 2008, 06:24 AM
jasonjetski is offline
Find More Posts by jasonjetski
Micro-Heli-Concepts
jasonjetski's Avatar
Australia, NSW, Blacktown
Joined Dec 2006
4,985 Posts
I found the reason I keep stripping the blade screws without the blades being tight is because on mine,Both top and bottom of the blade holder are threaded.So that means that the blade holders cant squeeze together unless the top bladeholder loses its thread,but the screws eat their heads first,So I just got a 1mm drill and drilled the upper blade holder screw hole out.
Now I can tighten the blades properly.
Jason
jasonjetski is offline Find More Posts by jasonjetski
Reply With Quote