View Single Post
Old Jun 05, 2008, 05:41 AM
jasonjetski is offline
Find More Posts by jasonjetski
Micro-Heli-Concepts
jasonjetski's Avatar
Australia, NSW, Blacktown
Joined Dec 2006
4,985 Posts
Quote:
Originally Posted by Ampdraw
mk,
Read of someone using stainless hypordermic needle tube as tail boom and a 1mm version for flybar (hollow too). That was material I wanted but difficult to find (like the braces rubber bands I use to remove slop between servo horn and swash had to buy from dentist!). Stain tube would have been sweet on V1 esp for the flybar. Wont need flybar change on B it seems. Only wonder if we take all flex (shock resistance) out of boom will we break mount and cause larger problem. Ca trick on original boom works well but time consuming (and heli's aren't!) and strengthens as well trying to avoid set screw completely . By the way 2.59-2.6mm is good thickness for fit in V1. Trying to find the link for the compatible parts V1 and B from German site cause no parts in Aus yet besides complete head.
Amp
Do you mean this page?
jasonjetski is offline Find More Posts by jasonjetski
Reply With Quote