Thread: Discussion DX6i USB cable & Throttle Hold?
View Single Post
Old May 25, 2008, 08:32 AM
mitchfx is offline
Find More Posts by mitchfx
Registered User
Altadena, CA
Joined Mar 2008
133 Posts
Stefan,

you are exactly right, I see that now. One thing I'm not sure about at this point is when setting up the controller for CV for use with a cp heli is do I calibrate and use the dx6i when already SET for that specific heli mode inside the tx? Or do I want to calibrate the ranges with the tx in some type of "generic/basic" mode, then switch to the heli program mode after calibration? Or possibly stay in a basic mode the whole time and let CV do the "program" curves? All this is very confusing to say the least.

thanks,
Mitch
mitchfx is offline Find More Posts by mitchfx
Reply With Quote