Thread: Discussion Compy 300 FP
View Single Post
Old Apr 28, 2008, 01:04 PM
mckolit is offline
Find More Posts by mckolit
Registered User
mckolit's Avatar
Southern California
Joined Apr 2007
820 Posts
Quote:
Originally Posted by maarset
Oh and I just thought to check the main shaft since the head was off the Compy.
It is not straight. It's not off by much but it is definitely bent.

Can I use a HBFP main shaft? My Compy rotor head sits too high which makes the linkage move out of the anti-twisting bar behind the head.
It would also be cool to use a different main Gear that the motor turns. Mine is still a little warped. So what is the hot setup I can get for the Main Gear and Main Shaft?
It is still going to need a pulley for the tail.

Mike
Unfortunately the hbfp main shaft is too short. Compy's original is a little too long. Best thing to do is just make your own linkages. If you have z bend pliers just make em out of some paper clips and superglue or hotglue it onto the ball link and you'll be good to go.
mckolit is offline Find More Posts by mckolit
Reply With Quote