View Single Post
Old May 05, 2003, 09:20 AM
mkirsch1 is offline
Find More Posts by mkirsch1
Registered User
United States, NY, Spencerport
Joined Oct 2001
2,801 Posts
All you have to do is disconnect the red wire going from the retract servo to the receiver.

Here's what I would do: Get a short quality Y-harness, a standard switch harness, and your retract battery. At the receiver end of the Y-harness, extract the center pin from the servo plug by carefully lifting the plastic catch with an exacto knife. Insulate this pin with heat shrink tubing to prevent any shorts. Now, just connect the battery and switch harness to the one leg of the Y-harness, and the retract servo to the other.
mkirsch1 is offline Find More Posts by mkirsch1
Reply With Quote